Pair of Crossover PCBs for the Econowave Delite 10 DIY speaker design - PCB Kit

Description

Custom printed circuit boards designed for the crossover of the Econowave Delite 10 DIY speaker (designed by the late great Zilch).
Take the guesswork out of crossover assembly, these boards make the assembly process quick and straightforward.
The boards measure 5.75" x 5" and features large solder pads and copper traces for great electrical connectivity
Note photos of fully assembled crossovers are for reference only.
Includes:
2x Crossover PCBs for the Delite 10 speaker design.
6x 2-pin Terminal blocks which accept up to 12 gauge wire.
2x 3-pin Terminal blocks
which accept up to 12 gauge wire.
8x Snap in PCB standoffs.
8x Mounting screws (screw finish may vary).
Requires:
Crossover components for the Delite 10 speaker design.
Compatible components tested for fit on this PCB:
C1 - 5.1uF - Dayton Audio DMPC-5.1
C2 - 30uF - Dayton Audio DMPC-30
C3 - 1.5uF - Dayton Audio DPMC-1.5
C4 - 2.2uF - Dayton Audio DPMC-2.2
L1 - 0.8mH -
Dayton Audio 0.8mH 20 AWG Air Core -or- Jantzen Audio 0.8mH 20 AWG Air Core
L2 - 1.5mH -
Dayton Audio 1.5mH 18 AWG I-Core -or- Erse Audio 1.5mH 18 AWG I-Core
L3 - 1.0mH -
Dayton Audio 1.0mH 20 AWG Air Core -or- Jantzen Audio 1.0mH 20 AWG Air Core
R1 - 8 Ohm - Dayton Audio DNR-8
R2 - 16 Ohm - Dayton Audio DNR-16
R3 - 3.7 Ohm - Dayton Audio DNR-3.7
Assembly:
Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.