Pair of Crossover PCBs for the Argos DIY speaker design - PCB Board Kit

Description

Custom printed circuit boards designed for the crossover of the Argos DIY speaker design.
Take the guesswork out of crossover assembly, these boards make the assembly process quick and straightforward.
The boards measure 5.5" x 4.25" and features large solder pads and copper traces for great electrical connectivity
Note photos of fully assembled crossovers are for reference only.
Includes:
2x Crossover PCBs for the Argos speaker design.
6x Terminal blocks which accept up to 12 gauge wire.
8x Snap in PCB standoffs.
8x Mounting screws (screw finish may vary).
Requires:
Crossover components for the Argos speaker design.
Compatible components tested for fit on this PCB:
C1 - 2uF - Dayton Audio DMPC-2
C2 - 3.3uF - Dayton Audio DMPC-3.3
C3 - 12uF - 12uF 100V Electrolytic Non-Polarized Crossover Capacitor
C4 - 33uF - 33uF 100V Electrolytic Non-Polarized Crossover Capacitor
C5 - 68uF - 68uF 100V Electrolytic Non-Polarized Crossover Capacitor
L1 - 0.50mH - Dayton Audio 0.50mH 20 AWG Air Core -or- Jantzen Audio 0.50mH 20 AWG Air Core
L2 - 1.0mH - Dayton Audio 1mH 18 AWG Air Core -or- Jantzen Audio 1.0mH 18 AWG Air Core
L3 - 0.30mH - Dayton Audio 0.30mH 20 AWG Air Core -or- Jantzen Audio 0.30mH 20 AWG Air Core
L4 - 0.40mH - Dayton Audio 0.40mH 18 AWG Air Core -or- Jantzen Audio 0.40mH 18 AWG Air Core
R1 - 15 Ohm - 15 Ohm 10W wire wound resistor
R2 - 5 Ohm - 5 Ohm 10W wire wound resistor
R3 - 20 Ohm - 20 Ohm 5W wire wound resistor
Assembly:
Glue components to the correct positions on the board (hot melt glue works great). Secure inductors with non metallic cable ties. Solder components leads to the pads on the bottom of the board. Attach wires from input and drivers and mount crossover board.